Temperature Control Unit
Oil unit for temperatures up to 250°C
Available as double-circuit unit with 2 x 8 kW

Operational use:
plastic / die casting moulds, small rollers and plates

Model Z    pump with axial face seal
Model A    pump with seal less magnetic drive

Temperature range up to 250°C with heat transfer oil TOOL-THERM SH-3
Temperature control self-optimizing, electronic microprocessor controller MP-888 with digital display of the set and actual value. Automatic temperature monitoring.
Flow control electronically, with digital display and automatic control of the minimum flow.
Heating capacity
Switchable in stages
8 kW
3 / 5
2 x 8 kW
2 x 3 / 5
Cooling capacity 60 kW
at 250°C circulating temperature
2 x 60 kW
Pump capacity
Pressure mode
Vacuum mode

Model Z
Model A
motor 1,8 kW
max. 5,5 bar / max. 100 l/min
vacuum max. 8 mH2O

pump with axial face seal and triple bearing system
pump with seal less magnetic drive
Temperature measurement at the mould yes yes
Leakstopper and mould drain yes yes
Expansion tank capacity 14 litres 1 x 46 litres
Filling Amount 9 litres 1 x 30 litres
Expansion volume 11 litres 1 x 36 litres
Oil circuit
Cooling water

3/4" BSP female thread
inlet     water filter              1" BSP female thread
outlet   non-return valve    1" BSP female thread
Dimensions (L×W×H) 1'130 × 390 × 1'070 mm 1'240 × 720 × 1'400 mm (incl. castors)
Weight approx. 150 kg empty approx. 325 kg empty
Colour silvergrey RAL 7001

MP-988 Microprocessor Controller for Digital Interfaces (RS-485 / RS-232 / Current Loop 20mA / CAN-bus / Profibus)

All possible voltages are available from 3 x 200 V to 3 x 600 V and 50/60 Hz.
The units are available conform to UL/CSA specifications. For the USA market the units are equipped with NPT-thread connections and the controller is adjusted to indicate °F.

Similar Products