Temperature Control Unit
For permanent temperatures up to 360°C with heat transfer oil
Heating capacity: 16 kW or 24 kW

Operational use:
Moulds in the die casting industry, small rollers and plates

Model Z    pump with axial face seal
Model A    pump with seal less magnetic drive

TECHNICAL DATA: TT-390 Z or A TT-390 Z or A
Temperature range up to 360°C with heat transfer oil TOOL-THERM SH-3
Temperature control self-optimizing, electronic microprocessor controller MP-888 with digital display of the set and actual value.
Automatic temperature monitoring.
Flow control electronically, with digital display and automatic control of the minimum flow.
Heating capacity
Switchable in stages
16 kW
8 / 8
24 kW
8 / 16
Cooling capacity 90 kW at 360°C circulating temperature
Pump capacity
Pressure mode
Vacuum mode

Model Z
Model A
motor 1,8 kW
max. 5,5 bar / max. 100 l/min
vacuum max. 8 mH2O

pump with axial face seal and triple bearing system
pump with seal less magnetic drive
Temperature measurement at the mould yes yes
Leakstopper and mould drain yes yes
Expansion tank capacity 21 litres 21 litres
Filling Amount 15 litres 21 litres
Expansion volume 16 litres 16 litres
Oil circuit
Cooling water

3/4" BSP female thread
1“ BSP male thread
inlet     water filter             1“ BSP female thread
outlet   non-return valve    1“ BSP female thread
Dimensions (L×W×H) 1‘240 × 480 × 1‘400 mm, incl. castors
Weight approx. 205 kg empty approx. 215 kg empty
Colour silvergrey RAL 7001

MP-988 Microprocessor Controller for Digital Interfaces (RS-485 / RS-232 / Current Loop 20mA / CAN-bus / Profibus)

All possible voltages are available from 3 x 200 V to 3 x 600 V and 50/60 Hz.
The units are available conform to UL/CSA specifications. For the USA market the units are equipped with NPT-thread connections and the controller is adjusted to indicate °F.

Similar Products