Temperature Control Unit
For permanent temperatures up to 360°C with heat transfer oil
Heating capacity: 2 x 16 kW or 2 x 24 kW

Operational use:
Moulds in the die casting industry, small rollers and plates

Model Z    pump with axial face seal
Model A    pump with seal less magnetic drive

TECHNICAL DATA:	TT-390/2 Z or A	TT-390/2 Z or A
Temperature range	up to 360°C with heat transfer oil TOOL-THERM SH-3
Temperature control	self-optimizing, electronic microprocessor controller MP-888 with digital display of the set and actual value. Automatic temperature monitoring.
Flow control	electronically, with digital display and automatic control of the minimum flow.
Heating capacity Switchable in stages	2 x 16 kW 2 x 8 / 8	2 x 24 kW 2 x 8 / 16
Cooling capacity	90 kW at 360°C circulating temperature
Pump capacity Pressure mode Vacuum mode Model Z Model A	motor 1,8 kW max. 5,5 bar / max. 100 l/min vacuum max. 8 mH2O pump with axial face seal and triple bearing system pump with seal less magnetic drive
Temperature measurement at the mould	yes	yes
Leakstopper and mould drain	yes	yes
Expansion tank capacity	1 x 46 litres	1 x 46 litres
Filling Amount	1 x 30 litres	1 x 42 litres
Expansion volume	1 x 36 litres	1 x 36 litres
Connections Oil circuit Cooling water	3/4" BSP female thread 1“ BSP male thread inlet     water filter             1“ BSP female thread outlet    1“ BSP female thread
Dimensions (L×W×H)	1‘240 × 720 × 1‘400 mm, incl. castors
Weight	approx. 335 kg empty	approx. 375 kg empty
Colour	silvergrey RAL 7001

Options:
MP-988 Microprocessor Controller for Digital Interfaces (RS-485 / RS-232 / Current Loop 20mA / CAN-bus / Profibus)

All possible voltages are available from 3 x 200 V to 3 x 600 V and 50/60 Hz.
The units are available conform to UL/CSA specifications. For the USA market the units are equipped with NPT-thread connections and the controller is adjusted to indicate °F.